Just bear with me for a little while as I’ll be documenting the main features, pinout, applications, and datasheet of this tiny component Tip42c. The 6A is collector current which indicates the value of loads this transistor can support. The 5V is the voltage across base and emitter terminals which projects the value of voltage required to bias this transistor. The voltage across collector and emitter terminals is 100V and the voltage across base and collector terminals is 100V. It is made up of silicon material and falls under the category of PNP transistors. Tip42c is a medium power transistor mainly used for amplification and switching purpose.
In this post, I’ll detail the Introduction to Tip42c. Premier Farnell plc 2011.Hi Friends! I welcome you on board. MULTICOMP is the registered trademark of the Group. Limit or restrict the Group's liability for death or personal injury resulting from its negligence. Liability for loss or damage resultingįrom any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. Should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. The Information is subject to change without notice and replaces all data sheets previously supplied. No licence of any intellectual property rights is granted. In connection with the products to which it relates. No licence is granted for the use of it other than for information purposes VR, Reverse Voltage (Volts)IB, Base Current (mA)ĭisclaimer This data sheet and its contents (the "Information") belong to the Premier Farnell Group (the "Group") or are licensed to it. To values less than the limitations imposed by second breakdown. Second breakdown pulse limits are valid forĭuty cycles to 10% provided TJ (PK) ≤150☌, At high case temperatures, thermal limitation will reduce the power that can be handled The data of curve is base on TJ (PK) = 150☌ TC is variable depending on power level. Subjected to greater dissipation than curves indicate.
Operating area curves indicate IC-VCE limits of the transistor that must be observed for reliable operation i.e. There are two limitation on the power handling ability of a transistor: average junction temperature and second breakdown safe RB and RC Varied to Obtain Desired Current Levels Thermal Resistance Junction to Case Rθjc 1.92 ☌/W (1) Pulse Test: Pulse Width ≤ 300µs, Duty Cycle ≤ 2.0%. Current gain-bandwidth product fT = 3.0 MHz (minimum) at IC = 500mA.Ĭomplementary Silicon Plastic Power TransistorsĮlectric Characteristics (TC = 25☌ unless otherwise noted)Ĭharacteristics Symbol Minimum Maximum Units.Collector-emitter saturation voltage-VCE (sat) = 1.5V (maximum) at IC = 6.0A.Collector-emitter sustaining voltage-VCEO (sus) = 100V (minimum).Original Transistor PNP TIP42C TIP42 6A 100V TO-220 Newĭesigned for use in general purpose power amplifier and switching applications.
0 kommentar(er)
